Timber to Masonry Hanger 175 x 75mm

Expamet BAT Masonry (built-in) Single Piece Hanger

Fixing Type
Built in to masonry - No mechanical fixings required to wall. 3.75x30 square twisted nails to connect joist.

Installation requirements
- Back of hanger must be tight against wall.
- Joists are to be cut square with a gap not exceeding 6mm from the rear of the hanger.
- A minimum 675mm of set masonry must be in place over support flange before loads are applied.
- Joist to be nailed through side gusset using 3.75x30mm square twisted nails.
- The underside of joists should be notched to provide a level surface for plasterboarding.

Features/Benefits
- Single piece, non welded construction
- Non coaxial fixing holes
- 600g/m2 galvanized coating
- Joists 150mm and above manufactured 10mm less to allow for notching/joist regularisation

Joist Height 175mm
Joist Width 75mm
Length 1 75mm Shoe
Projection 75mm Flange
Material Gauge 2.0mm
Coating 600g/m² Zinc Coating
Material Galvanized Mild Steel DX51D+Z600 to EN10346:2015
Fire Rating Euroclass A1

European Standard/ETA BS EN845-1:2013+A1:2016
Test Standard BS EN 846-8:2000
Notified Body Lucideon Ltd (NB 1289)