150mm Visqueen Polythene DPC
Visqueen Polyethylene Damp Proof Course
Features and benefits
Manufactured to British Standard - achieves minimum DPC requirements
Post use recycled content in excess of 90% - diverts waste from landfill
Diamond embossed surface - improves mortar adhesion
Minimum DPC standard - cost effective option
Product description
Visqueen Polyethylene Damp Proof Course is a black, flexible 0.5mm damp proof course suitable for masonry wall constructions.
It is supplied in 30m length rolls and the following widths: 100mm, 112.5mm, 150mm, 225mm, 300mm, 337.5mm, 450mm, 600mm,
900mm and 1200mm.
Approvals and standards
Manufactured to BS 6515:1984
CE Mark EN 14909:2012
Quality Management System ISO 9001:2015
Occupational Health and Safety System ISO 18001:2007
Environmental Management System ISO 14001:2015
Usage
Visqueen Polyethylene Damp Proof Course is suitable for various masonry applications in accordance with Appendix D of BS
6515:1984.
System components
Visqueen Zedex Jointing Tape, 100mm x 15m
Storage and handling
Visqueen Polyethylene Damp Proof Course should be stored vertically and under cover in its original packaging.
Care should be taken when handling the product in line with current manual handling regulations.
Preparation
Visqueen Polyethylene Damp Proof Course can be cut with a sharp retractable safety knife or robust scissors.
Installation
When built into a masonry wall construction, Visqueen Polyethylene Damp Proof Course should be installed on an even bed of wet
mortar, and any perforations in adjacent courses of masonry should be completely filled with mortar. To ensure mortar adhesion,
as soon as possible after laying the DPC, lay at least one further course of masonry including a bed of mortar.
If positioned on the sleeper walls below a suspended ground floor e.g. beam and block floor system, the DPC can be dry laid,
however all sharp protrusions must be removed from the substrate. The DPC must extend through the full thickness of the
masonry wall, including pointing, applied rendering or other facing materials.
All DPC to DPC laps should be a minimum of 100mm and bonded with Visqueen Zedex Jointing Tape.
Usable temperature range
It is recommended that Visqueen Polyethylene Damp Proof Course and all associated system components should not be used
below 5°C.
Additional information
Where a housing grade DPC or a cavity tray system is required, consider the use of Visqueen Zedex Housing Grade Damp Proof
Course.
Where a high performance DPC is required e.g for commercial or multi storey constructions, use Visqueen Zedex CPT High
Performance Damp Proof Course.
Where a gas DPC conforming to the specification requirements of BS 8485:2015 + A1:2019 is required, use Visqueen Gas
Resistant Damp Proof Course.